[. . . ] Installation using the screw holes on the side of the unit 1 2 Install this unit. Install this unit away from hot places such as near the heater outlet. [. . . ] € Place all cables away from moving parts, such as the shift lever and seat rails. € Place all cables away from hot places, such as near the heater outlet. € Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. € Never cut the insulation of the power cable of this unit in order to share the power with other devices. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle’s auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. Ground cables for this unit and other equipment (especially, high-current products such as power amps) must be wired separately. If they are not, an accidental detachment may result in a fire or malfunction. Factory radio mounting bracket Truss (5 mm × 8 mm) screws Dashboard or console T This unit 3 1 2 45 6 7 8 1 Power cord input 2 Microphone input 3 Microphone 4m 4 Rear output or subwoofer output 5 Front output En 3 Section 02 Connections Connections 6 Antenna input 7 Fuse (10 A) 8 Wired remote input Hard-wired remote control adapter can be connected (sold separately). Power cord 3 4 2 5 6 1 3 7 5 8 4 6 a 9 d c b 1 To power cord input 2 Depending on the kind of vehicle, the function of 3 and 5 may be different. [. . . ] 3 Clamp Use separately sold clamps to secure the lead where necessary inside the vehicle. 3 4 1 Microphone 2 Microphone base 3 Microphone clip 4 Fit the microphone lead into the groove. [. . . ]